MULTIQUIP DCa70ssJU4i Spezifikationen PDF herunterladen (Seite 2)

DCA70SSJU4i — LOAD BANK INSTRUCTIONS P/N EE58627 — REV. #1 (03/13/15) — PAGE 2

FRONT PANEL REMOVAL (TOW SIDE)

1. Locate the generator front panel as shown in Figure 2.

2. Remove the 12 screws (Figure 2 ) that secure the front

panel to the cabinet housing.

Figure 2. Front Panel/Exhaust Cover Removal

3. Remove front panel, set aside where it will not get

damaged.

FRONT FRAME EXHAUST COVER REMOVAL

1. Remove the 10 screws that secure the exhaust cover

(Figure 2) to cabinet housing.

2. Retain mounting hardware.

3. Discard front frame exhaust cover.

MUFFLER TAIL PIPE EXTENSION INSTALLATION

1. Locate mufﬂer tail pipe extension (P/N EE58370).

2. Place the ﬂanged end over the existing mufﬂer pipe

section as shown in Figure 3.

FRONT

PANEL

EXHAUST

COVER

CABINET

HOUSING

DISCARD

MOUNTING

HARWARE

WHISPERWATT

MOUNTING

HARWARE

Figure 3. Tail Pipe Extension

3. Secure tail pipe extension with U-Clamp (P/N

EE16745).

GROMMET INSTALLATION

1. Using a chassis punch or equivalent tool, cut a 2-inch

diameter hole into the front frame cabinet sheet metal

as shown in (Figure 4).

Figure 4. 2-Inch Diameter Hole Cut-Out

2. Remove any sharp edges from the hole opening.

3. Insert 2-inch diameter rubber grommet (P/N EE58673)

into hole opening.

MUFFLER

TAIL PIPE

EXTENSION

U-CLAMP

13.50”

5.50”

2.0” DIA.

EXISTING

HOLE/GROMMET

DRILL/C

NEW HOLE

BACK SECTION OF FRONT

FRAME CABINET

1 2 3 4 5 6 7 ... 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

MULTIQUIP DCa70ssJU4i Spezifikationen Seite 2

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Stromgeneratoren MULTIQUIP DCa70ssJU4i