MULTIQUIP MQ600TD80 Spezifikationen PDF herunterladen (Seite 25)

MQ600TD80 TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #8 (11/13/09) — PAGE 25

Operation

1. The MQ600TD80 trash pump should begin pumping

water within a minute depending on the length of suction

hose and height the pump is above water.

Longer suction hoses will require

more time for the pump to begin

pumping water.

2. If pump does not begin to pump water after a few

minutes, check for loose connections or air leaks in

suction hose. Make sure there is water in the pump end

and strainer is not clogged with debris, reference Table 8

(Pump Troubleshooting).

3. Slow down the engine and allow to cool for at least 2

minutes. Place

speed control lever

in the stop position

and listen for the engine to stop running.

NOTE

MQ600TD80 — INITIAL START-UP (ENGINE)

2. Turn the ignition key to the 0 position and remove the

key from the ignition switch.

NEVER attempt to stop the engine by moving the

decompression lever. Always use the speed control lever

to stop engine.

CAUTIONCAUTION

CAUTION

When pump is not in use, keep ignition starting key in a

safe place, out of the reach of unauthorized persons.

CAUTIONCAUTION

CAUTION

Engine Shut-Down

1. Slow down the engine and allow to cool for at least 2

minutes. Place

speed control lever

in the idle position

and turn the ignition key to the OFF position.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 65 66

Keine Kommentare

MULTIQUIP MQ600TD80 Spezifikationen Seite 25