MULTIQUIP GAW-135H Spezifikationen PDF herunterladen (Seite 16)

PAGE 16 — GAW-135H DC WELDER/AC GENERATOR — OPERATION MANUAL — REV. #0 (06/23/04)

GAW-135H — GENERAL INFORMATION

GAW-135H Familarization

General Inspection Prior to Operation

This generator/welder has been thoroughly inspected and

accepted prior to shipment from the factory. However, be

sure to check for damaged parts or components, or loose

nuts and bolts, which could have become disloged in transit.

The

MQ Model

GAW-135H generator/welder has been

designed as a portable lightweight power source for 60 Hz

(single-phase) vibrators, lighting facilities, power tools,

submersible pumps and other industrial and construction

machinery.

This generator/welder is powered by a Honda GX200VEN2,

5.5 HP, air-cooled gasoline engine. The alternator, a

brushless revolving-field type, is permanently aligned to the

engine through rigid coupling.

The generator is mounted on rubber vibration isolators that

have a steel base backplate which is attached to the

protective steel pipe carrying frame. The protective carrying

frame is made of steel tubing and fully wraps around the

generator to protect against damage.

This portable generator is supplied with a electrical

control

panel

. The control panel includes items as listed below.

Control Panel

The generator control panel has the following componets:

(1) NEMA Duplex Receptacle (GFCI) 5-20R (120V,

20 Amp)

One main 2-pole,15 Amp Circuit Breaker.

Idle Control Switch

Welding Terminal Lugs

Ground Terminal

Circuit Breaker

To protect the generator from an overload,

a 2-pole, 15 amp

circuit breaker is provided on the control panel. Make sure

to switch this circuit breaker to the "OFF" position prior to

starting the engine.

Excitation System

The MQ generator/welder uses a magnet attached to a

flywheel to produce AC voltage from a lamp coil beneath

the flywheel. As the magnet passes the coil it produces

approximately 19-22 AC volts.

This voltage (19-22 VAC) is then sent to the control box that

contains three rectifying diodes:

Excitation (diode 1)

Battery (diode 2)

Slow Down (diode 3)

The AC voltage will pass through the excitation diode that

converts the voltage to DC power.

This DC power is then sent to the excitation windings housed

within the main windings commonly called the "stator".

This voltage is then transferred into the rotor through

induction. The rotor contains two diodes within it which rectify

the DC voltage and send it out through the main windings,

as AC voltage.

Engine

The four-cycle air-cooled

Honda

gasoline engine is designed

to meet every performance requirement of this generator.

Reference Table 1, for engine specifications.

Figure 2 shows the basic controls and indicators for the

MQ GAW-135H generator/welder.

NOTE

In keeping with

Multiquip's

policy of constantly improving

its products, the specifications

quoted herein are subject to

change without prior notice.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 83 84

Kommentare zu diesen Handbüchern

Keine Kommentare

MULTIQUIP GAW-135H Spezifikationen Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Stromgeneratoren MULTIQUIP GAW-135H