MULTIQUIP DA7000SS Spezifikationen PDF herunterladen (Seite 40)

PAGE 40 —DA7000 SERIES A.C. GENERATORS— OPERATION AND PARTS MANUAL — REV. #4 (08/07/09)

A defective pintle hitch not properly fastened can result

in uncoupling, leading to death or serious injury.

Be sure the pintle hook is securly tighten to the tow vehicle

before coupling the trailer.

WARNING - Uncoupled Pintle Hitch Hook

Coupling the Trailer to the Tow Vehicle (Pintle Coupler)



Slowly back up the tow vehicle so that the pintle hitch

hook is near or aligned under the pintle eye ring coupler.



Using the jackstand at the front of trailer (tongue), turn

the jackstand crank handle to raise the trailer. If the

pintle eye coupler does not line up with the pintle hitch

hook, adjust the position of the tow vehicle.



OPEN the pintle hook locking mechanism (Figure 32).

Place the hook inside the eye coupler. CLOSE the pintle

hook mechanism.



Insert a pin or lock through the hole in the locking

mechanism.



Be sure the pintle hook is inserted completely through

the eye ring and the locking mechanism is engaged. A

properly engaged locking mechanism will allow the cou-

pler to raise the rear of the tow vehicle. Using the trailer

jack, test to see that you can raise the rear of the tow

vehicle by1-inch after the coupler is locked to the hitch.



Lower the trailer so that its entire tongue weight is held

by the hitch.



Raise the jackstand to a height where it will not interfere

with the road.

Figure 32. Bumper Pull Trailer (Pintle Hitch)

DA7000 SERIES GENERATORS — TRAILER SAFETY

Connecting the Safety Chains

Connect the safety chains as shown in Figure 33. When

attaching the safety chains from the trailer to the tow ve-

hicle, be sure to cross the chains.

Figure 33. Safety Chain Arrangement

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 165 166

Keine Kommentare

MULTIQUIP DA7000SS Spezifikationen Seite 40